Changes between Version 16 and Version 17 of WikiStart

Timestamp:

Sep 29, 2013, 6:00:22 PM (12 years ago)

Author:

dominic

Comment:

--

WikiStart

@@ -45 +45 @@
     - Solder 4 wires to the TTL side of the level shifter. Ground, +3.3V, TX and RX need to be connected
     - Buy a 2x13 IDC connector which attaches to the Pi's GPIO pin headers (e.g. [http://de.rs-online.com/web/p/idc-steckverbinder/3237902/ RS-Online])
-    - Connect the four wires coming from the TTL side of the level shifter to the IDC connector. Pin layout depends on the version of your Pi. See [http://www.raspberrypi-spy.co.uk/2012/06/simple-guide-to-the-rpi-gpio-header-and-pins/ GPIO Pins]. If you have a revision 2 Pi this is the pin connection: Pin1=+3.3V, Pin6=GND, Pin8=TX, Pin9=RX. 
+    - Connect the four wires coming from the TTL side of the level shifter to the IDC connector. Pin layout depends on the version of your Pi. See [http://www.raspberrypi-spy.co.uk/2012/06/simple-guide-to-the-rpi-gpio-header-and-pins/ GPIO Pins]. If you have a revision 2 Pi, this is the pin connection: Pin1=+3.3V, Pin6=GND, Pin8=TX, Pin9=RX. 
     - Disable console output and boot messages on the serial interface. See [http://www.irrational.net/2012/04/19/using-the-raspberry-pis-serial-port/ here]