Changes between Version 43 and Version 44 of construction_guide

Timestamp:

Feb 24, 2014, 10:06:16 PM (11 years ago)

Author:

smoser

Comment:

--

construction_guide

@@ -46 +46 @@
 Then turn on the power supply. You should see the Raspberrys LEDs light up, indicating that the 5V power supply is working correctly.
 
-Connect now the communication cable with the Flarm device. You should also see that the device starts the boot sequence.
+Connect GPS receiver and antenna with the Flarm device. Connect the RJ45 connector from the communication cable with the Flarm device. The Flarm should initiate the boot sequence immediately.
 
 Finally connect the Raspberry to the network.
@@ -134 +134 @@
 
 
+
+
 ==== Final installation ====